Use an Ultra Lightweight Surgical Stands to Prevent Accidents in Traffic
Use an Ultra Lightweight Surgical Stands to Prevent Accidents in Traffic
Installing a Surgical Headlight Stands is relatively simple.surgical headlight stand All you need are some screws, nuts and bolts to hold everything together. Once the mounting frame is in place, tighten the screws carefully so that the light does not come tumbling down. Snap the plastic mounting canopy in place and pop the new reflector on to the front of the light. Instantly replace the old reflector with the new one.
There are two ways to do this, depending on which model your car has.surgical headlight stand Either remove the Hanger Hooks from the light source and re-attach them, or you can slide the light source out of the mounting plate and re-stick the hangers. Most cars come with plastic Surgical Headlight Stands kits that have mounting plate, hanger hooks and screws to fasten the lights. If your car doesn't have one of these, there are universal quick release hooks you can use. You may also want to consider universal clips if your car doesn't have a factory-installed headlight cover.
Now it's time to connect the fiberoptic cable to the Surgical headlight kit light head. Start by installing the fiber optic cable to the Surgical headlight switch. Then attach the fiber optic wire from the rear of the headlight to the female adapter in the center of the light head. The female adapter plugs into the male adapter on the light head to create the necessary connection.
The next step is to attach the fiberoptic cable to the overall dimensions of the stand. Use clips on both ends of the fiber optic cable 9 feet long and 2 inches apart. The clips should be placed on the inside lip of the entire headband and the outside of the light headband. Since the stand is only tall x 22 diameter base, you may use the inside lip and outside lip as support. In order to ensure that the stand keeps its overall dimensions, you will need to drill the holes and use some silicone caulk to seal the drilled holes.
After applying the silicone caulk to the drilled holes, you will need to position the stand on the car roof. With the stand attached to the car roof, you will need to attach the fiberoptic cable to the Surgical headlight switch and to the overall dimensions of the stand. This will provide you with the proper light angle so that you can see the numbers clearly from any angle. Using the same technique you used for the frame, you will need to attach the wires to the overall dimensions of the headband and to the side rails of the light head. The last step is to secure the whole structure with screws and latches.
There are many brands available in the market, but the manufacturer which offers the best quality product is the Ultralite Plus 9300xsp300w surgical headlight system. It is durable, comes with an easy to read manual and has a fiberoptic connector, making it very convenient to use. The manufacturer also makes sure that it is very easy to mount because of its pre-drilled mounting holes. One of the best features is that there is no heat conduction when the system is used in the correct manner. You can count on this brand.